Rockwell Automation 20D PowerFlex 700S and 700H Frame 10...12 Rectifier Module Replacement Kit - Manual (Page 23)

23
Publication PFLEX-IN023A-EN-P
1. Remove the four M4x8 POZIDRIV screws that secure the ASIC board
cover to the assembly and lift the cover off the assembly - you must unplug
the cable for the ASIC board assembly fan from connector X1 on the ASIC
board in order to remove the cover.
ATTENTION: The sheet metal cover and mounting screws on the
ASIC Board located on the power structure are energized at (-) DC
bus potential high voltage. Risk of electrical shock, injury, or death
exists if someone comes into contact with the assembly.
Remove screws
Upper-left corner of drive
PZ2
1.5 N•m
(13.3 lb•in)
ASIC assembly