Rockwell Automation LiquiFlo 1.0 and 1.5 External Bus Resistor Kit (500/640 Amp) - Manual (Page 5)

Instruction Manual D2-3536 5
Step 3: Drilling the Mounting
Holes
!
ATTENTION: Metal debris or other foreign matter must be
kept from falling into the drive. Metal debris or other foreign
matter may become lodged in the drive circuitry resulting in
component damage. Failure to observe this precaution could
result in severe bodily injury or loss of life and/or damage to, or
destruction of, equipment.
Task Description
Protect internal components from drilling debris
Using the template, mark locations for six mounting holes
Drill six 5mm (3/16 inch) mounting holes
A
B
C
Drilling Template /
Cabinet Guard
A
B
B
B
B
B
B
TIP: The template is symmetrical, so you have the options of drilling from
the outside or inside of the enclosure. Drilling outside reduces the risk of
debris falling into the drive.