Rockwell Automation Direct Drive Technology Demonstration Machine - Manual (Page 14)

14 Publication PMC-QS002B-EN-P - October 2008
Chapter 1 Install the Direct Drive Technology Demonstration Machine
Make Connections
1. Attach the keyboard USB and mouse infrared receiver to the
Velcro on the support arm with the sensor side towards the
keyboard.
2. Connect the USB and mouse cable to computer.
3. Connect computer power and network cable to the side of the
machine.
4. Place mouse and keyboard on stand.
5. Connect the machine to a 230V AC, 10 A minimum single phase
power main.
Preparing the Direct
Drive Technology
Demonstration Machine
for Shipment
To prepare the Direct Drive Technology Demonstration Machine for
shipment pack the machine following the installation instructions in
reverse. Reuse the packing material and the tie wraps that were sent with
the machine.
Network Cable
Keyboard and Mouse
Infrared Receiver
Computer
Power Cord
Main Power
Switch
Emergency Stop,
Stop, Run Buttons