Rockwell Automation Direct Drive Technology Demonstration Machine - Manual (Page 7)

7 Publication PMC-QS002B-EN-P - October 2008 7
Chapter
1
Install the Direct Drive Technology
Demonstration Machine
Introduction
In this chapter, you will install Direct Drive Technology Demonstration
Machine.
Before You Begin • The packing material can be saved for use when the machine is
returned.
• Choose an installation location that is within 2 m (6.5 ft) of power
mains and meets the environmental and power specification for
the machine.
• The machine and the boxed contents of the shipping crate should
be brought to the location of the installation.
What You Need • Utility knife or snip for cutting tie wraps.
• Hex wrench set and an adjustable crescent wrench. These tools
were shipped with the machine.
• Additional tie wraps have been included. Use them to repack the
machine.
Topic Page
Before You Begin 7
What You Need 7
Follow These Steps 8
Position and Level Machine 8
Remove Shipping Clamps 9
Install Signs 12
Assemble Computer and Computer Stand 13
Make Connections 14
Preparing the Direct Drive Technology Demonstration Machine for
Shipment 14