Follow these steps, Machine start up, B. push the laser pointer down to turn it on – Rockwell Automation Direct Drive Technology Demonstration Machine User Manual
Page 16: C. tighten the hold down screw, D. close front door, Follow these steps machine start up
16
Publication PMC-QS002B-EN-P - October 2008
Chapter 2 Using the Direct Drive Technology Demonstration Machine
Follow These Steps
Complete the these steps to start the machine and the application
software.
Machine Start Up
Follow these sequence to start the machine.
1. Close the back door.
1. Open the front door.
a. Turn the laser pointer so the ON button is perpendicular to the
carriage.
b. Push the laser pointer down to turn it on.
c. Tighten the hold down screw.
d. Close front door.
2. Pull the emergency stop (E-stop) switch.
3. Turn the power ON.
4. Press Run (green button) on front side of machine.
Wait for the amplifiers count up to 4. It will take approximately 30
seconds for 3 to process.
5. Press Run again.
After the axis homes the machine will start cycling.