Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface Installation and Configuration Guide - Manual (Page 19)

Rockwell Automation Publication H2H-IN001A-EN-E–July 2012 19
Chapter 4
Configuring FactoryTalk Historian To
Historian Interface
To configure the H2H Interface, perform the following steps:
1. Create an interface instance in the ICU (page 19).
2. Create a target point on the target server (page 21).
3. Configure a trust on the target server (page 22).
4. Configure a trust on the source server (page 22).
5. Start the H2H Interface (page 22).
6. Verify the H2H Interface (page 23).
NOTE
The configuration steps are based on the assumption that
FactoryTalk Historian To Historian Interface is installed on the
target server.
To create an instance of the H2H Interface:
1. Go to Start > All Programs > Rockwell Software > FactoryTalk
Historian SE > Interface Configuration Utility. The Interface
Configuration Utility dialog box appears.
2. From the menu bar, select Interface > New Windows
Interface Instance from EXE. The Configure a New
Interface dialog box appears.
3. Click Browse. The Locate Interface dialog box appears.
Create an Interface
Instance in the ICU