Introduction, Terminology, Chapter 1 – Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface Installation and Configuration Guide User Manual
Page 5
Rockwell Automation Publication H2H-IN001A-EN-E–July 2012
5
Chapter 1
Introduction
The FactoryTalk Historian To Historian Interface is used to
transfer data from a Rockwell Historian server (s
ource server) to
another Rockwell Historian server (
target server). This includes a
Rockwell FactoryTalk Historian ME module, a FactoryTalk
Historian SE server or a collective of FactoryTalk Historian SE 3.0
servers being transferred to another Rockwell FactoryTalk Historian
SE 3.0 server or a collective of FactoryTalk Historian SE 3.0 servers.
You will find here information about:
• Supported architectures (page 6).
• Licensing (page 9).
• Installing FactoryTalk Historian To Historian Interface (page
• Configuring FactoryTalk Historian To Historian Interface
(page 19).
• Removing FactoryTalk Historian To Historian Interface
(page 29).
NOTE
For the latest information on the FactoryTalk Historian To
Historian Interface, please refer to the KB article 58662
Individual components of the FactoryTalk Historian SE and
FactoryTalk family products may be referred to in this document
using the following abbreviations and naming conventions:
Terminology