Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface Installation and Configuration Guide - Manual (Page 29)

Rockwell Automation Publication H2H-IN001A-EN-E–July 2012 29
Chapter 6
Removing FactoryTalk Historian To
Historian Interface
To remove FactoryTalk Historian To Historian Interface from your
computer, choose either of the following methods:
• Using the Start menu (page 29).
• Using Control Panel (page 30).
• Using the distribution kit (page 30).
NOTE
Stop the Batch interface before you start the removal process.
To remove the suite using the Start menu:
1. Go to Start > All Programs > Rockwell Software > FactoryTalk
Historian SE.
2. Click the Uninstall link of the FactoryTalk Historian suite
you want to remove from the computer.
The removal wizard appears.
3. On the wizard pages, click Next and then Uninstall to start
the removal process.
4. Click Finish.
5. In the message that appears, click OK to complete the removal
process.
Removing the Suite Using
the Start Menu