Bang & Olufsen BeoCom 3 - User Guide - Manual (Page 23)

23
BeoCom 3 has additional,
‘advanced’ settings, apart from
those available in the ‘Setup’
menu.
These settings allow you to:
– enter the area codes which fall
within your local calling area;
– adjust the time it takes to
execute a ‘flash’ between calls
on the same line;
– preset the display contrast for
optimum viewing of display
information;
– choose to store calls from other,
connected phones in the
BeoCom 3 Redial list;
– choose a menu language;
Enter area code settings
Settings for the use of area codes are
entered during first-time setup of
BeoCom 3, but can be adjusted at any time
from the Advanced settings menu. Please
refer to First-time setup of BeoCom 3 for
more information about the ‘Area codes’
menu.
Preset a flash time
The requirements telephone companies
have for the duration of a ‘flash’ – a switch
to another call on the same line – may
differ. You can preset a flash time.
In most cases, it will be unnecessary to adjust
flash time, as flash times should either match the
’short’ or ’long’ settings. If you experience
problems with the flash function, please contact
your telephone company for the precise flash
time.
Advanced settings
Area codes
Dial : Yes
Area code : 555
Area code 1 :
Flash time
Short
Long
Customized
Menu
OK
OK
OK
OK
0 – 9
C
OK
Press to view the main menu
Turn the wheel to select ‘Setup
menu’ and press OK
Turn the wheel to select
‘Advanced menu’ and press
OK. ‘Area codes’ is already
highlighted
Press OK
Turn the wheel to select either
‘Dial’ or ‘Area code’ and press
OK
Press the digit keys to enter
area codes
Press C to go back to a
previous digit, or…
…press OK to store your
entries
Menu
OK
OK
OK
OK
OK
Press to view the main menu
Turn the wheel to select ‘Setup
menu’ and press OK
Turn the wheel to select
’Advanced menu’ and press
OK
Turn the wheel to select ’Flash
time’ and press OK
Turn the wheel to select short,
long or customized flash time
(in milliseconds) and press OK
If you choose a customized
flash time, turn the wheel to
adjust the flash time and press
OK to store the setting