Bang & Olufsen BeoCom 6000 - User Guide - Manual (Page 6)

Get started
Charge the handset battery
If the handset requires charging, this occurs automatically when
the handset is placed in the charger. For safety reasons, the
battery is not charged prior to shipping. We recommend that you
charge the handset for at least one hour before proceeding
further with first-time registration of the handset.
About charging …
– The charger must be connected to the power outlet.
– It takes four hours to fully charge the battery.
– The maximum talk­time per charge is approximately 15 hours.
– Standby time per charge is approximately 200 hours.
Battery status
The battery indicator in the display shows the charge level of the
handset battery. If the batteries require charging, you are alerted
by a message in the display and a sound signal.
To display the battery status …
Press while the handset is in standby
Turn the wheel until Battery status is shown and
press OK. The current charge level appears in
the display
When getting started, follow this
procedure:
1 Connect the charger to the
power outlet as described in the
charger’s Guide
2 Charge the handset battery
3 Connect the BeoLine base as
described in the BeoLine Guide
4 Register the handset to the base.
25%
50%
75%
The handset controls the battery
charging, so you can always place
the handset in the charger after
use, even if the battery does not
need recharging. Leaving the
handset in the charger does not
reduce the lifetime of the battery.
OK
OK
Battery status
Battery status
= = = = = = = = =
======
===
6