Baumfolder BAUM20: Autoset Service Manual for Pile feed User Manual
Page 11
8.21 Press the “Deflect All” button
, so that the pan will go to its deflect position.
NOTE: FOLDER DRIVE MOTOR MUST BE OFF AT THIS TIME.
8.22 Repeat steps 8.11 through 8.20 for all the pans to be calibrated.
8.23 Turn off folder drive.
8.24 After everything is calibrated, Press the “Home” button to return to the main screen.
IX. AUTOSET 16 PAGE PAN CALIBRATION
9.1 Before starting the 16 page calibration, a 16 page fold must be set in Autoset.
9.2 Get folder ready to run paper. Set a single sheet under each gap set in the parallel and 2 sheets under
each gapset in the 8-page and 4 sheets under each gapset in the 16 page.
9.3
17 X 22 paper must be loaded on feed table.
9.4
Go to main page and press “Maintenance” button.
9.5
This will bring up the Maintenance screen. From the Maintenance page press the “Machine Setup”
button.
9.6 This will bring up a keypad to enter the password. Enter
4921281
then press “Enter”.
9.7
This will bring up the Machine Setup page. From this page press the “Calibration Page” button.
TP10512
TP10512
8 of 16