Baumfolder BAUM20: Autoset Service Manual for Pile feed - Manual (Page 18)

13.3 Remove the cover from the fold plate electrical box.
13.4 Unplug the (2) connectors 7-2 going from the motor to the drive board.
13.5 Remove the (4) screws 7-1 that connect the fold plate electrical box to the casting.
1 2 3
Fig. 7
13.6 Slide the fold plate electrical box 7-3 off of the motor.
13.7 Remove the (4) set screws from the motor gear hub so it can be removed from the motor shaft.
Note: (2) set screws per hole.
13.8 Remove gear 8-1 from motor shaft.
13.9 Remove the (2) mounting screws 8-2 holding the motor and remove the motor.
13.10 Install the new motor, motor orientation must be the same as the removed motor see figure 8.
1 2
Fig. 8
13.11 Insert gear 8-1 onto motor shaft, align gears and set screw must sit on flat of motor shaft. Note: set
screws must be reinstalled with blue LOCTITE, (2) set screws per hole in gear hub.
13.12 Mount motor guard, reconnect motor wire connectors and reinstall covers.
TP10512 TP10512 15 of 16