Baumfolder BAUM20: Autoset Service Manual for Pile feed - Manual (Page 4)

I. AUTOSET: A LIST OF DO NOTS:
1.1 Never initiate Autoset while fold rolls are running . If any of the pans move in or out of deflect the
pan deflectors will scrape across the fold roll, damage to the fold roll or pan deflector could occur.
1.2
Never plug in or unplug Autoset communication cables, without turning off Autoset power
switch
. This includes the pan and stacker cables. Damage to the motor controllers could occur.
1.3 Never initiate Autoset after a power up, all pans and stacker must be homed first . Damage could
occur to the drive train of the pans or the stacker belt could be disconnected or damaged.
1.4 Never put fingers into fold pans with Autoset powered up . Injury to fingers will occur if pinched
in fold pan movement.
1.5 Never continually press a series of screen buttons when Autoset is in process of moving fold
pans, let Autoset complete each task before initiating another Autoset move
. Pans will most
likely be out of position and will not know where they are at. Please home all pans if this occurs.
1.6 Never use any other instrument than the operator’s finger to navigate the Autoset screens . See
warranty note on page 4.
II. Autoset machine configuration instructions: For service technicians use only!
2.1 You can get back into the Machine Configuration screen at anytime by
going to the main page then touching the Maintenance button
Fig. 1
2.2 Once in the Maintenance screen touch the Machine Set-up
button.
Fig. 2
2.3 This will bring up a keypad asking you to enter
the password. Enter the password 4921281 then touch the
enter button.
Fig. 3
TP10512 TP10512 1 of 16