Baumfolder BAUM20: Autoset Service Manual for Pile feed User Manual
Page 7
V. CLEANING TOUCH SCREEN COMPUTER
It is very important to shut down the Autoset computer before cleaning the computer screen. Use a
CRT screen cleaner ONLY on the interface touch screen.
VI. AUTOSET COMPUTER WARRANTY NOTE
WARNING – Damage to the computer screen will occur if any instrument other than the
operator’s finger is used to navigate the Autoset screens. NOTE: Warranty on the computer will be
void if this is found to be the case for computer failure.
VII. AUTOSET PARALLEL PAN CALIBRATION
7.1 Get folder ready to run paper. Set a single sheet under each gap set.
7.2
Select a half fold and the paper must be 11 X 17.
7.3
Go to main page and press “Maintenance” button.
7.4
This will bring up the Maintenance screen. From the Maintenance page press the “Machine Setup”
button.
7.5 This will bring up a keypad to enter the password. Enter
4921281
then press “Enter”.
7.6
This will bring up the Machine Setup page. From this page press the “Calibration Page” button.
TP10512
TP10512
4 of 16