Blakeslee UC-20 - Manual (Page 12)

11
PROGRAMMABLE MODE
The programmable mode allows an operator to manually select and program a custom wash and rinse
cycle. Selections include:
Wash and rinse mode
• Low
• Medium
• Heavy
Temperature Modes
• Wash - 150°F to 170°F
• Rinse - 180°F to 190°F
The default in the wash mode is “low”. The default in the temperature mode is 150°F wash and 180°F
rinse. To change either one of these settings, press and hold the Select Cycle Up and Down Keys
simultaneously for fifteen seconds. This will prompt the dishwasher into a setup screen. To change
Wash and rinse mode, press the Select Cycle Down Key until the desired cycle appears on the display
screen. Press the Select Cycle Up Key to save the cycle. Repeat for wash and rinse temperature
settings. When all selections have been made, press the Start/Enter switch to exit the setup screen.
Shutdown and Cleaning
An important part of maintaining the dishwasher is keeping it clean. A thorough cleaning before shutting
the unit down will help keep it working at peak performance.
Shutdown
1. Press dishwasher once to allow dishwasher to fully drain.
2. Press Power On/Off switch a second time to power down the unit.
Cleaning
1. Open door and allow interior to cool down before cleaning.
2. Remove the scrap filter screens and empty them. Take them to a sink and clean them using a
suitable brush. Make sure all debris is removed. Rinse thoroughly.
3. Inspect the rotating wash arms for blockage of any opening and free rotation. Remove and
clean as needed.
4. Thoroughly wash and rinse the interior of the dishwasher.
5. Leave door open to dry interior.