Blakeslee UC-20 - Manual (Page 8)

7
ELECTRICAL CONNECTIONS
WARNING
Before performing any service that involves electrical connection or disconnection and/or
exposure to electrical components, always perform the Electrical LOCKOUT/TAGOUT
Procedure. Disconnect all circuits. Failure to comply with this procedure can cause property
damage, injury or death.
Refer to the unit’s data plate before making any electrical connections.
Any connections must correspond to the information specified on the data plate. A fused disconnect
switch or circuit breaker (not supplied) MUST be installed in the electrical supply line for the
dishwasher.
This service connection must meet all local and national electrical code requirements. All connections
are made at one common location in the control box. The control box cover is lipped and can be
opened by removing two (2) #10-32 screws.
Use ¾” knockout hole in back of dishwasher to connect to terminal block located on front of unit.
Incoming connection shown below.
240 Volt 1 Phase