Blakeslee UC-20 - Manual (Page 14)

13
ERROR CODES
Resetting an error code
An error code can be reset by pressing the Power On/Off switch three consecutive times. If the error
code fails to reset, refer to the below chart before contacting factory.
ERROR CODES
B1 heat alarm Check power connection to booster element
B2 rinse failed Check incoming water supply and flow pressure
B3 overheating Contact factory
E1 water load Open the main water supply valve. Contact factory
T1 heating Check power connection to tank heating element
T2 overheating Contact factory
T3 drain Check drain pump operation and sump filter
T4 sensor Check for proper polarity connection and/or loose connection
T5 high level Drain and load tank
T6 low level
Drain and load tank
Check incoming water and flow pressure