Brandmotion 9002-9510-V1 - Manual (Page 2)

9510 Instructions 9-18-12 Tel 734-619-1250
2 of 3 Toll Free 877-276-6456
Fax 480-247-5999
Harness Pinout:
Pin Wire Color Function
1 N/A N/A
2 N/A N/A
3 Dark Green Low Speed LAN
4 N/A N/A
5† Varies Exterior Auto Dimming +
6 White Video +
7 Brown Video -
8 Black Ground
9 Green Reverse Signal 12V+
10 N/A N/A
11† Varies OnStar Keypad Signal
12† Varies OnStar Keypad Supply Voltage
13 Red Ignition Controlled 12V+
14† Varies OnStar Keypad Green LED Signal
15† Varies OnStar Keypad Red LED Signal
16† Varies Exterior Auto Dimming -
†These pins may be populated in vehicles equipped with OnStar and/or exterior auto dimming mirrors.
Wiring: (It may not be necessary for you to use the Green, White and Brown supplied wires below, most GM vehicles already
have these locations populated. If wires already exists in these locations simple test the leads using a multimeter for the
correct signal).
Inserting/ removing pins: located on the bottom side of the mirror connector is a rectangular white tab. This tab must first be
released (see figure 1). A small flathead watch repair screw driver works best. The tab will only lift about 1/10
th of an inch.
Then insert the same screwdriver (or Delphi terminal tool 12094429) on the face of the connector and lift the plastic tab that
holds the pin in place (see figure 2).
Figure 1 Figure 2