Brandmotion 9002-8501 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
8501 Instructions 7-18-13.doc Page 3 of 4
Step 13: Splice the red and green Chassis Harness
leads into the corresponding vehicle wires and the
black wire to chassis ground. (Note: Soldering
recommended or T-taps as optional connection
method). RECOMMENDED: Attach an eyelet to the
black ground wire.
Step 14: Route Camera Harness towards the side of
the vehicle that supplies power.
Step 15: Connect Camera Harness to supplied
Chassis Harness. The optimal location for this junction
may occur at the top of the liftgate or the inner edge
of the trunk. (Note: Most vehicles have existing wires
passing through this area; use this route if at all
possible).
Pinout Reference Chart
PIN
#
FUNCTION
CAMERA
HARNESS
COLOR
CHASSIS
HARNESS
COLOR
1
Video
(+)
Yellow
White
2
Shield
White
Blue
3
Reverse
Blue
Green
4
Video
(-­‐)
Brown
Brown
5
Ground
Black
Black
6
Ignition
Red
Red
Step 16: Route Chassis Harness forward. It may be
necessary to remove sill plates, pillar covers, seat
bases, side panels, etc. using a Plastic Trim Removal
Tool. In some cases, seatbelt bolts must be removed.
(CAUTION: Any bolts removed for safety devices
must be retightened to manufacturer’s torque
specifications).
Step 17: Secure Camera Harness to existing
vehicle wiring. This will minimize chance of
binding or otherwise damaging the harness.
RECOMMENDED: Wire Ties or Electrical Tape.
Step 18: (if required): Install aftermarket video
display or mirror per manufacturer’s instructions.
Step 19: Connect Chassis Harness to the female
RCA jack of your aftermarket video display or
mirror.
Step 20: Test the system. Inspect that all
connections are proper and secure. Clear all loose
items removed from the area around the vehicle
and turn ignition key ON to test system. Once
Reverse gear is engaged the camera image
should appear.
Step 21: Secure Chassis Harness. If necessary,
coil excess harness and secure. Attach harness to
existing vehicle wiring where possible.
(RECOMMENDED: Wire Ties or Electrical Tape.)
Step 22: Adjust camera aim. With the aid of an
assistant, move camera to desired view. Use a
Phillips screwdriver to fully tighten the bolts that
hold the camera in place.
Step 23: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care
not to bind the harness wiring when reinstalling.