Brandmotion 1009-6503 - Manual (Page 2)

INSTALLATION
INSTRUCTIONS
6503 Instructions 2-4-14.Doc Page 2 of 8
5. Remove the handle access panel inside the tailgate
using a T30 Torx driver. (NOTE: If vehicle is
equipped with a bed liner, the tailgate portion of the
liner must be removed prior to this step.)
6. Remove nuts attaching handle to tailgate using an
8mm Socket, then remove handle from tailgate.
(NOTE: Non-power locking tailgate mechanism
shown.)
7. If equipped, remove the lock cylinder from existing
handle.
8. If equipped, remount the lock cylinder in the
supplied Tailgate Camera Handle using an 8mm
Socket and existing hardware.
9. Use a Utility Knife or Side Cutters to remove the
Rubber Grommet closest to the camera end from
the Camera Harness. Wrap the Camera Harness with
Electrical Tape where you removed the grommet.
10. Route the gray Camera Harness connector and
wiring through tailgate and install supplied handle
using an 8mm Socket with the existing hardware.
11. Reinstall handle bolts.