Brandmotion 9002-8535 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
8535 Instructions 5-28-14.docx Page 3 of 3
Step 13: Connect Camera Harness to supplied
Chassis Harness. The optimal location for this
junction may occur at the top of the liftgate or the
inner edge of the trunk. (Note: Most vehicles have
existing wires passing through this area; use this
route if at all possible).
Pinout Reference Chart
PIN
#
FUNCTION
CAMERA
HARNESS
COLOR
CHASSIS
HARNESS
COLOR
1
Video
(+)
Yellow
White
2
Shield
White
Blue
3
Reverse
Blue
Green
4
Video
(-­‐)
Brown
Brown
5
Ground
Black
Black
6
Ignition
Red
Red
Step 14: Route Chassis Harness forward. It may
be necessary to remove sill plates, pillar covers,
seat bases, side panels, etc. using a Plastic Trim
Removal Tool. In some cases, seatbelt bolts must
be removed. (CAUTION: Any bolts removed for
safety devices must be retightened to
manufacturer’s torque specifications).
Step 15: Secure Camera Harness to existing
vehicle wiring. This will minimize chance of binding
or otherwise damaging the harness.
RECOMMENDED: Wire Ties or Electrical Tape.
Step 16: Use a Plastic Trim Removal Tool, 7mm or
10mm Socket, and/ or Phillips Screwdriver to
remove garnish and fasteners securing radio
display.
Step 17: Pull the radio and locate small 4 pin
receptacle on the back of the radio. CAUTION: Be
careful not to disconnect antenna or other
connection to back of radio.
Step 18: Plug the 4-pin Jumper Harness connector
into the female receptacle on the back of the radio.
Step 19: Connect Chassis Harness male RCA
connector to Jumper Harness female RCA
connector.
Step 20: Connect the Red and Green wire of
Chassis Harness to the Red wire of the Display
Harness and Black wire of Chassis Harness to Black
wire of the Display Harness. (RECOMMENDED:
Solder wires and cover with Heat Shrink Tubing)
Step 21: Use Electrical Tape to secure Chassis
Harness and Jumper Harness RCA connection.
Step 22: Coil any excess Chassis Harness and
secure it and the Jumper Harness to existing
vehicle wiring with Wire Ties or Electrical Tape.
Step 23: Reinstall radio display and inspect that all
connections are proper and secure.
Step 24: Test system. Close trunk or liftgate and
clear all removed items from around the vehicle
before starting the vehicle. Next, shift into Reverse
and check radio display for the camera image.
Step 25: (If necessary) Adjust camera aim.
Reposition camera to the desired viewing angle.
Step 26: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.