Brandmotion 1008-6502 - Manual (Page 5)

INSTALLATION INSTRUCTIONS
6501 and 6502 Instructions 6-13-12.doc 5 of 20
Section 3: Chassis Harness Installation continued
15. Center punch and drill a pilot hole then drill
a 1 inch hole with a hole saw.
16. Clean the hole with a deburring tool (Figure
15).
Figure 15
17. Recommended: Use a cotton swab or small
brush to apply corrosion inhibitor to
exposed edges (Figure 16).
Figure 16
18. Route the supplied chassis harness through
the drilled opening and seat the grommet
from the inside of vehicle (Figure 17).
Figure 17