Brandmotion FDMC-1220 - Manual (Page 4)

INSTALLATION
INSTRUCTIONS
1220 Instructions 6-26-14.docx Page 4 of 5
Step 13: Route black connector of Charging
Module through 1/2" hole and place module
in bin. Flip tray over and insert the (4) 3/8”
Pan Head T-15 Torx Screws through tray into
module.
Step 14: Install Non-Slip Freedom Charge
Mat to Wireless Charging Module. Place the 4
locator pins in corresponding holes.
Step 15: Firmly press Mat around LED.
Step 16: Attach Ground Eyelet of Power
harness to upper 13mm Bolt on drivers foot
well metal console bracket.
Step 17: Pull down driver side knee bolster
trim to reveal interior air sensor plug.
Step 18: Splice Red wire of Power Harness to
the Blue (12v ignition) wire of the interior
sensor plug.
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing