Brandmotion FDMC-1260 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
1260 Instructions 6-26-14.docx Page 3 of 5
Step 7: Disconnect power point plug from
vehicles console.
Step 8: Splice Red wire of Power Harness to
the Red/Yellow (12v ignition) wire of the
power point plug and Splice Black wire of
Power Harness to the Black (ground) wire of
the power point plug
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing.
Step 9: Route black connector of Charging
Module through 1/2" hole of rubber tray
liner.
Step 10: Route black connector of Power
Harness through 1/2" in upper console trim.
Step 11: Connect Power Harness to Charging
Module.