Brandmotion FDMC-1210 - Manual (Page 9)

INSTALLATION
INSTRUCTIONS
1210 Instructions 6-27-14.docx Page 9 of 12
Section 4: Drop-In Mounting
(from above)
Follow the next step if you cannot reach the
underside of your mounting location. Please
be sure there is ½” under mounting location
and clear of any vehicle wiring of
components prior to drilling.
Step 24: Assembly of Substrate to Freedom
Charge module for Drop-In Mounting from
above. Insert (2) ¼” Torx Flat head screws
through substrate into Freedom Charge
Module. This will leave two open chamfered
holes.
Step 25: Place new assembly into vehicle
tray or bin to mark ½” hole location require
for power connector to pass through. Drill
½” hole in marked location.
Step 26: Route Plug of Charging Module
through 1/2" hole and place module in bin.
Mark the hole locations by inserting center
punch or scribe tool through the 2 chamfered
holes and firmly marking.
Step 27: Remove Charging Module and Drill
1/8" holes at the previous 2 marked
locations.