Bully Dog 53153 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 10)

9
RFI COLD AIR INTAKE
Installing the RFI Intake
1. Mount the RFI Enclosure Base in the space made by
removing the stock intake. Use the three machine screws
that you set aside during the removal of the stock intake
(step 6) to secure it in the engine bay.
2. Connect the stage 2 air intake tube to the Bully Dog air intake
tube (with MAF mount) and the turbo inlet tube in the engine
bay. Leave the band clamps loose until you are sure that all
of the connections are properly aligned, and then tighten the
clamps with a flat-head screwdriver.
IMPORTANT: Do not overtighten the screws, as this could damage the Bully Dog intake.
IMPORTANT: You will need to move the MAF sensor cable when installing the stage 2 intake tube. Pull
the cable to the side to prevent the tube catching and damaging it. Then put it back in place once the
tube has been installed.