Rfi cold air intake – Bully Dog 53153 Rapid Flow Induction (RFI) Cold Air Intake User Manual
Page 9
Advertising
8
RFI COLD AIR INTAKE
3. Swap the OEM MAF O-ring for the Bully Dog O-ring.
4. Attach the MAF sensor to the Bully Dog intake tube. Use the
nylon washers and the black oxide Phillips screws provided
by Bully Dog. Use two washers on each side.
5. Connect the silicone couplers to the stage 2 air intake tube.
Do not tighten the band clamps. Leave them loose so you
can adjust the couplers into the correct position.
5.5” Band Clamp
5.5” Band Clamp
Silicone Coupler
Silicone Hump Coupler
5” Band Clamp
5” Band Clamp
Stage 2 Tube
IMPORTANT: Do not overtighten the screws, as
this could damage the MAF sensor.
Advertising