Bully Dog 53153 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 6)

5
RFI COLD AIR INTAKE
Installation
Installation is very simple, and
can be separated into three
parts: Removing the Stock
Intake, Preparing the Bully
Dog RFI Intake and Installing
the Bully Dog RFI Intake. The
complete installation of the
RFI Cold Air Intake system
should take about 20 minutes.
The assembly diagram below
shows how the parts of the
intake fit together in sequence.
Removing the Stock Intake
1. IMPORTANT Before beginning installation, disconnect
your battery at the negative terminal.
Failure to disconnect the battery
could result in personal injury and/
or damage to your vehicle.
OEM Intake Box (5)
Band Clamp (3)
Band Clamp (3)
Stock Intake Tube (4)
Mass Air Flow Sensor (2)