DJI Z15-5D - Manual (Page 18)

©2013 DJI Innovations. All Rights Reserved.
18
Setting the AUX3 Switch
The Z15-5D supports camera video recording. Please wire the right channel of receiver to AUX3 port. Every toggle
is set for start/stop recording.
The Assistant Software
Installation and Usage
Step1: Make sure the driver is installed correctly and has been installed beforehand if you use A2, WKM, ACE
ONE or ACE WAYPOINT.
Step2: Please download the assistant software installer from the DJI Innovations website.
Step3: Double click the assistant software installer file and follow the steps to finish installation.
Step4: Run the assistant software.
Step5: Please upgrade the firmware and configure the parameters according to the assistant software
indications if necessary.
Test
Check List Before Flight
Notes:
 The gimbal is installed firmly to the landing gear, and the camera is mounted correctly and stably.
 All cables are correctly connected, without any connected back to front.
 The gimbal video signal cable is in good soldered condition if wireless video transmission module used.
 Correct connection between the GCU and RC receiver.
 Normal connection between the GCU and flight control system.
 Correct camera setup.
 Correct Transmitter settings.
 The firmware of flight control system has been upgraded to the latest version.
Tips:
 Please turn to the Trouble Shooting section in Appendix if an abnormal situation occurs.