DJI Z15-5D - Manual (Page 20)

©2013 DJI Innovations. All Rights Reserved.
20
Appendix
Important Notes
For safety reasons, please pay serious attention to all following items:
 Ensure nothing blocks the servo driver module rotation, to avoid motor damage.
 Before powering on, spin the gimbal by hand through the complete rotational axes to ensure nothing
is blocking the mechanical movement of the gimbal.
 Ensure that the side of the servo driver module 1 with ports correctly points towards the aircraft tail
direction.
 The gimbal center of gravity has been set, which directly determines the gimbal’s performance.
Please do not adjust the gimbal center of gravity by yourself.
 The gimbal is a high-precision controlled instrument. Do not remove any screws in the gimbal. Doing so may
result in decreased performance or even damage.
 Do not unplug any cables which are attached to the gimbal ports, or attempt to change or customize the
mechanical structure.
 Make sure the cable connections are correct and secure to ensure the gimbal works normally and is in full
control.
 Make sure to connect the Wireless Video Transmission module to the gimbal controller before
powering on the system.
 The factory gimbal video signal cable is recommended. Make sure you solder the gimbal video signal
cable to the wireless video transmission module correctly. And ensure the cables are insulated, to
prevent a short circuit .
 Make sure the current consumption of wireless video transmission module does not exceed 1A, to
prevent the GCU from damage.
 Keep the gimbal away from any power cables; otherwise it may lead to a short circuit of the gimbal.
 Make sure to adjust the Roll axis of the gimbal to be level before powering on.