Belkin UCSPRO-RM2 - Manual (Page 3)

LTO LTO
TM
2
Introduction
Thank you for choosing the ALTO Mobile UCSPRO-RM2 Programmer for the Alto Mobile UCS PRO digital
signal processor. The UCSPRO-RM2 provides an alternative to using a Personal Computer (PC) for setting
the various functions of the UCS PRO. It is primarily designed to be bolted to the UCS PRO but can be
detached and, using an optional extension data cable, used remote from the main unit (such as handheld at
the driver's seat) during system set-up.
While unable to offer the advanced graphics interface available when using the PC Editor, the UCSPRO-RM2
does offer all the same control and set-up functions. It does this via a very intuitive set of controls, a multi-
layer menu system, and its own backlit LCD display.
The UCS PRO is a 2 input, 6 output device offering several forms of signal processing designed to
manipulate and enhance the audio signal in a number of ways. These include multiband parametric
equalization, high-pass and low-pass filters, digital channel delay (time alignment), phase alignment,
multichannel dynamic control (compressor/limiter), noise gating and full input/output gain setting in the
digital domain. The addition of the UCSPRO-RM2 makes the UCS PRO a completely self-contained "car
audio tweaker's paradise", allowing system set-up, further fine adjustment and preset selection to be done at
any time without the need to hook-up a computer.
We have attempted to provide detailed instructions in this manual, but it does assume that the person
installing and setting up the equipment already has a good level of knowledge of the subject. If you have had
your UCS PRO professionally installed and set-up for you, please be aware that altering the settings may
damage audio system components.
The UCS PRO has a password access system that your installer may have set in mode to
safeguard the settings. If you are unable to access menu items with the UCSPRO-RM2, check with your
dealer.
NOTE:
Lock
TM