Belkin UCSPRO-RM2 User Manual
Page 9
8
LTO
LTO
TM
arrow key.
When you have finished selecting a new name for your preset,
. Storing preset names is one
time when you must press ENTER. If you press ESC, your new set-up will not have been stored.
Every time you make changes to the settings of the UCS PRO using the RM2, we recommend you
save the new set-up under a new Preset Number. This will ensure that the original settings are available for
instant recall. DO NOT overwrite an existing Preset Number with a new set-up unless you are sure you no
longer want the original set-up.
To Load a preset previously stored in the memory of the UCS PRO, select MODE >
.
should show in the display, with a flashing number below it. The
or
next to the number indicates if it is a
actory Preset or a
ser Preset. The flashing digit signifies that it's an editable parameter - choose another
preset number by turning the rotary knob, then press ENTER.
There are a total of 64 User Preset locations. Presets 1C to 128C refer to a memory card - this function is not
supported by the UCS PRO (see
).
press ENTER
NOTE:
Loading Presets
F
U
F
U
Preset Load Preset
Functions not applicable to the Rm2
EDITING PARAMETERS USING THE RM2