Banner SureCross DX80 Wireless Networks - Manual (Page 3)

After making the necessary changes to the DIP switches, place the black cover plate back into position and
gently push into place. Plug the ribbon cable in after verifying that the blocked hole lines up with the missing
pin. Mount the cover back onto the housing.
DIP Switch Settings
Switches
Device Settings 1 2
Rotary dial address mode OFF*
Extended address mode ON
Analog Configuration OFF*
Discrete Configuration ON
* Default configuration
Address Mode
The SureCross wireless devices may use one of two types of addressing modes: rotary dial addressing or extended addressing. In
rotary dial address mode, the left rotary dial establishes the network ID and the right rotary dial sets the device ID. The wireless network
is restricted to a maximum of 16 devices.
Extended address mode uses a security code to "bind" Nodes to a specific Gateway. Bound Nodes can only send and receive informa-
tion from the Gateway to which they are bound. In extended address mode, wireless networks may contain up to 48 radio devices. For
more information on extended address mode, refer to the SureCross™ Wireless I/O Network product manual.
The device ships in rotary dial address mode by default, with the DIP switch in the OFF position. To use extended address mode, change
the DIP switch to the ON position.
Analog or Discrete Configuration
Select between an analog configuration or a discrete configuration using the DIP switch specified in the table. The default switch settings
for this device are all in the OFF position.
DIP Switch Settings for Analog Configuration (Switch 2 OFF)
Select between an analog configuration or a discrete configuration using DIP switch 2.
For analog configuration, DIP switch 2 is in the OFF position (factory default). Analog configuration has analog IN 1 linked to switch
power 1 (SP1) and is programmable using switches four through eight. Sample and report rates for analog input 2 (not available in the
integrated battery model) are listed in the specifications. Discrete inputs 1 and 2 are also active in this configuration and the input types
are defined using switch 3. Two sinking discrete outputs are active for this configuration.
Analog Configuration, Switch 2 OFF DIP Switches
Descriptions 3 4 5 6 7 8
Discrete Sinking (NPN) OFF*
Discrete Sourcing (PNP) ON
Boost Voltage: 10V (to Analog IN 1) OFF*
Boost Voltage: 15V (to Analog IN 1) ON
Warm-up Time 10 milliseconds OFF*
Warm-up Time 500 milliseconds ON
Sample/Report Rate 1 second OFF OFF OFF
Sample/Report Rate 2 seconds OFF OFF ON
Sample/Report Rate 4 seconds OFF ON OFF
Sample/Report Rate 16 seconds OFF ON ON
SureCross DX80 FlexPower Node
P/N 131296 Rev. L www.bannerengineering.com - tel: 763-544-3164 3