E-flite Beechcraft Bonanza 15e ARF - Manual (Page 15)

15 Beechcraft Bonanza 15e ARF Assembly Manual
□
Step 6
Turn the fuselage upright while using the hex wrench
to hold the rear mounting screw in place. Set the
V-tail in place over the mounting screw and use the
wrench to secure it in place.
□
Step 7
Turn the fuselage over. Place a small amount of
threadlock on the threads of the second screw and
insert it into the forward mounting hole. Use a 3/32-
inch hex wrench to tighten it into place.
□
Step 8
Use low-tack tape to center the ruddervators and
use your radio to center the servos.
□
Step 9
Adjust the clevises to align them with the control
horns. Connect each pushrod to the outer hole in
the control horns and secure the clevises with the
silicone keepers.
□
Step 10
Perform steps 1 through 7 on pages 7 and 8 to
locate and drill the mounting holes in the tailcone.
Use a #1 Phillips screwdriver to install the tailcone
with three #2 x 1/4-inch woodscrews.