E-flite Beechcraft Bonanza 15e ARF - Manual (Page 41)

41 Beechcraft Bonanza 15e ARF Assembly Manual
□
Step 12
Pull the motor wires from the ESC through the
firewall and connect each wire to its matching
colored wire from the motor.
□
Step 13
Push the connectors and excess wire through the
firewall under the battery tray.
Cowling and Spinner Installation
Parts Required
Fuselage Canopy
Spinner Propeller
Silicone keeper Propeller adapter
Cowling #2 x 1/4-inch screws (4)
Tools Required
Awl Manila card stock
Ruler Low-tack tape
Pin vise 1/16-inch drill bit
Thin CA Felt-tipped pen
Hobby knife with #11 blade
#1 Phillips screwdriver
Rotary tool with drum sander
□
Step 1
Cut four tabs from Manila card stock that measure
2 1/2 x 1/2-inch each. Use a punch to make a hole
centered along the length and 3/16-inch from the
end of each tab.
□
Step 2
Align two tabs to the top and bottom and flush to
the forward edge of each fuselage side where it
protrudes beyond the firewall. Tape them in place
with low-tack tape.
□
Step 3
Use a 1/16-inch drill bit in a pin vise to drill a 3/8-inch
deep hole in the fuselage at each tab location.