E-flite Beechcraft Bonanza 15e ARF - Manual (Page 35)

35 Beechcraft Bonanza 15e ARF Assembly Manual
□
Step 19
Place the nose gear on the rails 1/4-inch behind the
front and between the marked lines. Use a pencil to
mark the mounting hole locations on the rails.
□
Step 20
Use a pin vise in a 5/64-inch drill bit to drill the
mounting holes in the rails.
□
Step 21
Apply 1–2 drops of thin CA to each of the mounting
holes to strengthen the wood. Allow the CA to cure
completely without using accelerator.
□
Step 22
Place the nose gear on the mounting rails and feed
the servo wire through the holes in the bulkheads to
the radio compartment.
□
Step 23
Use a #1 Phillips screwdriver to install the nose gear
with four #4 x 7/16-inch countersunk wood screws.
□
Step 24
Connect the steering cable steel clevis to the slotted
tab on the nose gear and secure it with the silicone
keeper.