E-flite Cap 232 BP ARF - Manual (Page 15)

  5. Wick thin CA into the joint between the
wing and fuselage. Make sure to apply CA
to left, right, top and bottom to guarantee the
wing is glued securely.
Note: Avoid using a CA accelerator to allow the
CA to wick well into the wood of the fuselage and
wing. This will provide the best bond between the
two items.
 4. Slide the wing back into position in the
fuselage. Check to make sure the wing is
perpendicular (90°) to the fuselage as shown.
Lightly sand the opening in the fuselage if
necessary to make any adjustments.
90º 90º
15