E-flite Cap 232 BP ARF - Manual (Page 20)

  4. Slide the hinges and elevator into position
on the stabilizer. Align the end of the elevator
with the end of the stabilizer. Remove the
T-pins to position the elevator as close to the
stabilizer as possible, eliminating the gap
between the two. Saturate each hinge, top
and bottom, with thin CA.
Note:.Do.not.use.CA.accelerator.on.the..
hinges..The.CA.must.be.allowed.to.soak.into.
the.hinges.and.surrounding.wood.to.provide..
the.best.bond.
 5. Repeat Steps 2 through 4 to install the
remaining elevator. Apply thin CA to the elevator
joiner as well as the hinges.
20