E-flite Cap 232 BP ARF - Manual (Page 22)

Landing Gear Installation
Required Parts
Assembled airframe
Tail gear wire
Tail wheel, 3/4" (20mm)
Tail wheel retainer
Main gear strut (2)
Main wheel, 1
7 / 8
" (48mm) (2)
Wheel spacer (2)
4-40 nut (4)
4-40 x 1/2" machine screw (2)
2mm x 15mm machine screw (2)
2mm nut (2)
Required Tools and Adhesives
Pliers
Phillips screwdriver (small)
Hex wrench: 3/32"
Thin CA
6-minute epoxy
Threadlock
 1. Locate the tail gear wire. Use 6-minute
epoxy to glue the wire into the slot in the bottom
of the rudder.
22