E-flite Cessna 182 370 ARF - Manual (Page 15)

15
 3. Slide the motor mount and motor onto the motor
stick. Use a hobby knife to drill a hole through
the plastic and into the motor stick. Secure the
gearbox using a 2mm x 8mm wood screw. We
suggest adding one or two additional screws to
the sides on the outrunner stick mount.
Hint: You may want to plug in the speed control
before installing the motor mount.
 4. Secure the speed control location using hook
and loop. Run the lead from the speed control to
the receiver. It may be necessary to use a servo
extension. Exact speed control location may vary
depending on the brand used and the center of
gravity. This photo shows the location in the front
of the fuse if you are using our E-flite™ 20-amp
Brushless ESC.