Bunn LCR-3 - Manual (Page 10)

10
Rinse Alarm Feature
Periodic rinsing of the mix chambers and dispense tips is essential for proper maintenance and optimum
performance of the dispenser. The automated Rinse Alarm feature has three levels of operation; see Programming
the Dispenser to select the desired alarm mode.
Alarm Level Alarm Mode
Disabled None
Warning Only “Rinse Required” will be displayed 4 hrs prior to the selected time interval to remind the
operator that the Rinse Procedure needs to be preformed soon. The dispenser will continue
to serve product, even if the full time interval elapses.
Brew Lockout “Rinse Required” will be displayed 4 hrs prior to the selected time interval to remind the
operator that the Rinse Procedure needs to be preformed soon. However, the dispenser will
Lockout and not continue to serve product once the selected time interval has elapsed.
NOTE: The time interval between Rinses is adjustable from 8 to 24 hrs. The dispenser is shipped with the Rinse
Alarm disabled, (No Alarm). It is up to the user to determine the Rinse time interval and the level of warning
required, based on their application and maintenance procedures.
Rinse Procedure:
1. Select Rinse on the Function Selector switch.
2. Place a 2 Liter (1/2 Gal) container under the dispense tip.
3. Activate any of the dispense switches until the water flow stops automatically, approximately 10 sec. The
Rinse Alarm message will go away, when the Rinse procedure has been satisfied.
4. Select Run on the Function Selector switch.
1 4
41129 120909