Bunn LCR-3 - Manual (Page 9)

9
INITIAL FILL & HEAT
1. Confirm the water supply is on.
2. Connect the dispenser to the power source.
3. Turn the Master ON/OFF Switch ON and select RUN on the Function Selector Switch. The LCD will display
“Tank Filling – Please Wait!” and water will begin flowing into the tank.
4. Once the tank is full the dispenser will start heating the water and display “Heating – Select Flavor”. Dispenser
models with product chillers will also begin to cool the cabinet at this time.
5. The LCD will display “Ready Select Flavor” when the tank temperature reaches the preset Ready
Temperature.
Note: The time required to heat the water initially will vary depending on the AC Power and the temperature of
the incoming water. While the tank is heating, the dispenser may be readied for use as described in Programming
Functions & Basic Operations.
3
4
41129 052208