GBC 2000 Plockmatic Bookmaker - Manual (Page 16)

1. Basics
16
Removing / replacing stapler Head
Removing / replacing staple Cartridge, continued
After staple jam or empty staple cartridge has been detected, the BM 2000 will
automatically advance and feed staples. This feature is called staple recovery. Follow
procedure below after a staple jam or empty staple cartridge indication.
Follow step 1-6 on the previous page.
Close the top cover.
Feed in a four page set. The staple recovery will commence now.
Now the BM 2000 has recovered and production can continue. In case problem
persists and no staples were fed, the display will indicate that again.
In such a case:
Repeat this procedure. If problem still persists, perform the Removing/replacing Stapler
Head procedure.
Select A (11x17”) paper size to facilitate
removing or replacing the stapler head.
Loosen the thumb screw (A).
Rotate the locking pin (B) towards the thumb
screw and remove the locking pin from the stapler
head assembly.
Disconnect the staple detection lead (C).
Push the stapler head towards the in-feed side,
out of the stapler head assembly.
A B C