GBC 2000 Plockmatic Bookmaker - Manual (Page 42)

6. T
roubleshooting
42
Booklet Maker fault Codes
Trimmer fault Codes
Waste Bin full
This message will be displayed when the trim bin is full or when a trim strip is prevented
from falling down into the trim bin. Empty the trim bin and remove loose trim strips from
inside the Trimmer. See section 1 Basics for how to remove the trim bin.
Check staples
This message will be displayed when a staple cartridge is empty or when stapling could
not be performed. Check in the following order:
If a staple cartridge is empty, replace according to section 1 Basics.
If staple cartridges are OK; remove the set and check that the number of sheets is
within specifications.
If staple cartridges are OK and the set is within specification, remove and check stapler
head according to section 1 Basics.
Close trimmer belts
This message will be displayed when the when either trimmer belt is in the lifted position. Make
sure that both the infeed roller shaft and the exit compressing brackets are in the operating
position, see section 5, Trimmer, Clearing Misfeed(s).
Too many sheets
This message will be displayed when the set fed to the Booklet Maker is outside
specifications. Open the top cover, remove the set and close the top cover.
Remove stacked sheets
This message will be displayed if there is a miss-feed or double-feed in the Feeder/Collator
when the set is delivered to the Booklet Maker.
Either:
Open the top cover, remove the set and close the top cover.
or
Press the “Purge” button on the Feeder/Collator. The set will be fed to the belt stacker.
and/or
Press the green button on the Feeder/Collator to directly start making booklets.
•
•
•