GBC 2000 Plockmatic Bookmaker - Manual (Page 19)

19
1. Basics
setting up narrow width paper sizes
If you are setting up a paper width less than 210 mm
(8.27”) and the stapler assemblies are in the default
position, the side guide extensions (B) must be removed.
Loosen thumb screws (A), one on each side
guide.
Remove both side guide extensions (B).
If required, also move the Stapler and Clincher
positions closer together. See “Changing Stapler
and Clincher position” above.
note
Make sure to re-install the side guide extensions
after the run. Otherwise paper jams might occur. B A