GBC 1064WFC Arctic Titan - Manual (Page 10)

© 2006 General Binding Corporation Page 10
SAFETY SENSORS
EMERGENCY STOP (Artic Titan 1064 WF c)
TABLE INTERLOCK LATCH
Fig. 5-2. Safety Sensor Location
Fig. 5-3. Emergency Stop Button
(Artic Titan 1064 WF c Only)
A. Safety Sensor (Figure 5-2)
The infrared safety sensors prevent entanglement,
entrapment, and inadvertent contact with the rollers. The
sensors are located on each side of the machine, in front of
the bottom roller. They stop the machine when a hand or
object blocks the invisible infrared beam if you are not
using the foot switch.
When the foot switch is used, the speed drops to 3 fpm
(0.9 m).
WARNING: Keep your fingers and hands
away from the nip point. Failure to observe this
warning could result in severe personal injury.
Emergency Stop Button (Figure 5-3)
The emergency stop button is on the left side of the
Artic Titan 1064 WF c laminator. To engage, press the
push button and roller movement stops. To disengage, turn
the push button clockwise once the emergency condition
has been resolved.
A. Table Interlock Latch (Figure 5-4)
The interlock latch locks the feed table into position and
activates an interlock switch. The latch is located on the
left, underside of the feed table. Move the latch to the right
to release the table. Then lift the table upwards and away
from the laminator.
A
Fig. 5-4. Table Interlock Latch under the Table
A