GBC 1064WFC Arctic Titan - Manual (Page 13)

© 2006 General Binding Corporation Page 13
CONTROL PANEL
POWER SWITCH
FOOT SWITCH
C
D
E
B
A. Speed Adjustment (Figure 5-10)
Turn the speed adjustment knob to set the desired speed. It
is adjustable from 0Ft/mn to 18Ft/mn
(0.8 to 4 m).
B. LED
WARNING: Keep your fingers and hands away
from the nip point (the point where the upper and
lower rollers meet). Failure to observe this
warning could result in severe personal injury.
C. RUN
Press and release RUN for continuous running. The green
LED illuminates.
D. STOP
Press STOP to stop the machine
E. REVERSE
Press and hold REVERSE to reverse the direction of the
rollers. Release the button to stop. The green LED
illuminates while the button is pressed.
F. FOOT
When the Foot Sw2itch is used, the FOOT LED while
illuminate Green to indicate that the Foot Switch is
overriding the safety system.
A. Power Switch (Figure 5-11)
B. Power Cord
C. Foot Switch Cord
The power switch is located at the back of the machine.
Press the “I” on the switch to turn it on. An orange LED
will illuminate next to the stop button. The off position,
marked “0”, turns the machine off. The power cord is
detachable and the foot switch is not.
Foot Switch (Figure 5-12)
The foot switch allows the operator to start and stop the
laminator while handling the item to be laminated.
Press the foot switch to run the laminator. Release it to stop
the laminator.
When the foot switch is used and the safety sensor is
blocked, the speed of the laminator drops to 3 fpm (0.9 m).
A
Fig. 5-10. Control Panel
Fig. 5-11. Power Switch, Power Cord
and Foot Switch Cord
A
B
C
F