GBC 1064WFC Arctic Titan - Manual (Page 25)

© 2006 General Binding Corporation Page 25
OPERATOR MAINTENANCE
CARING FOR THE Artic Titan 1040 WF c OR 1064 WF c LAMINATOR
The only maintenance required by the operator is to periodically clean the rollers. The following procedure will help
keep them free of dirt and adhesive, which has been deposited along the edge of the laminating film. Proper alignment
of the rolls of film reduces the amount of adhesive on the rollers. Perform only the routine maintenance procedures
referred to in these instructions.
WARNINGS:
•
Do not attempt to service or repair the laminator.
•
Do not apply any cleaning fluids or solvents to the rollers. Some solvents and fluids could damage the
rollers.
•
Keep fingers and hands away from the rollers when the machine is running. They could be trapped and
crushed in the rollers. Clothing, jewelry, and long hair could be caught in the rollers and pull you into
them.
Failure to observe these warnings could result in severe personal injury or death or damage the machine.
CLEANING THE ROLLERS
Keeping the rollers clean ensures that your finished items will not be damaged by dirt and adhesives. Clean the rollers
with a clean, damp lint free cloth. If there are any adhesive build ups, you may use isopropyl alcohol instead of water.
•
Never clean rollers with abrasive, sharp, or pointed objects.
•
Do not use any other cleaning agents other than those listed above.
•
Accumulated adhesive deposits on the rollers can cause damage to the rollers. Rotate the rollers at the lowest
speed setting on the control panel.
To clean the rollers and idler bar:
1. Remove the print clamp (Artic Titan 1064 WF c) and feed table. Refer to Removing and Installing the Print
Clamp (Artic Titan 1064 WF c) and Removing and Installing the Feed Table in the Operation chapter.
2. Remove the film from the laminator. Refer to Loading Film onto the Supply Shafts in the Operation chapter.
3. Use the dampened rag to remove any dust, dirt, and other foreign materials from the rollers.
4. Press and release the foot switch to rotate the rollers to an unclean portion. Keep your hands, fingers, pad, and rag
away while running the machine. Be sure to remove all adhesive and dirt.
5. Install the feed table and print clamp (Artic Titan 1064 WF c).