GBC 1064WFC Arctic Titan - Manual (Page 16)

© 2006 General Binding Corporation Page 16
REMOVING AND INSTALLING THE
PRINT CLAMP (Artic Titan 1064 WF c)
REMOVING AND INSTALLING THE
FEED TABLE
A
B
Fig. 6-4. Print Clamp and Feed Table
The print clamp guides prints into the rollers. It should be
removed when mounting items to thicker boards. It also
needs to be removed to install films and when cleaning the
rollers.
A. Release Latch (Figure 6-4)
B. Print Clamp (Figure 6-4)
WARNING: Keep fingers and hands away from
the rollers when the machine is running. They
could be trapped and crushed in the rollers.
Clothing, jewelry, and long hair could be caught
in the rollers and pull you into them.
To remove the print clamp:
1. Slide and hold either the left or right latch towards the
center of the laminator.
2. Lift the end of the print clamp up while disengaging
the opposite end.
To install the print clamp:
1. Position one end of the print clamp so that its latch
engages into its locking hole.
2. Lower the other end while retracting the latch so that
the latch lines up with its locking hole.
3. Release the latch and ensure that both latches are
engaged.
The feed table should not be removed except to install
films. When the table is off, the laminator runs at a fixed
speed of 3 fpm (0.9 m). Refer to Fig. 6-5 for the following
instructions.
A. Table Interlock Latch (Figure 6-5)
To remove the feed table:
1. Slide the feed table latch to the right.
2. Lift the table upwards and away from the laminator.
To install the feed table:
1. Place the table on the machine.
2. Slide the feed table latch to the left.
Fig. 6-5. Table Interlock Latch
A