BridgeWave AR80 - Manual (Page 16)

AR/GE/FE/U 80/80X Installation Manual
11 580­00519 rev. D
from the radome and rotate the radome so the drain hole is
at the bottom. Be careful not to contaminate, damage or
smudge the shiny coating of the antenna surface or
feedhorn and make sure the gasket is evenly seated when
re­attaching the radome cover.
1. Attach the upper pole mount to the antenna
mounting plate.
Confirm that the mount is centered as shown.
Tighten bolts securely.
Figure 3.5­1: Upper pole mount attached to antenna
mounting plate
2. Attach the lower pole mount and azimuth fine
adjust as shown.
Hardware: Flat washer, bushing (inside eye),
flat washer, lock washer, bolt.
Figure 3.5­2: Azimuth fine adjust assembly